Benefits to You
- Maximum efficiency will lower energy cost
- Improves dependability
- Prolongs the life of your equipment
- Prevents costly repairs
- Maintains safe and healthy operation
- Helps to protect the environment
- Discounts on any and all repairs
- Get 1 full year warranty on repair parts instead of 90 days
- Priority Scheduling
- Discounts available for upgrade items
- No overtime rate for emergency repairs
Residential Cooling and Heating Inspection
Our technicians will perform the following checks:
Up to 21 Point Inspection
- Check thermostat operation
- Inspect filter
- Check operating pressures
- Check caps & start components
- Inspect and test safety switches
- Check & document superheat & subcool (cooling)
- Inspect wiring & tighten electrical connections
Up to 56 Point Maintenance
- Check defrost components
- Inspect contractors, relays, and circuit boards
- Inspect indoor blower and motor for dirt buildup
- Inspect bearings and lubricate all moving parts
- Inspect duct seal at unit and secure panels
- Check voltage and amperage to all motors & compressor
- Check & document system temperature split
- Test defrost
- Inspect disconnect
- Inspect condensate drain
- Inspect outdoor coil
- Inspect indoor coil
- Inspect surge protection
- Run and test system
Outdoor Section
- Inspect fuses
- Inspect bearings & oil outdoor motor (as needed)
- Temperature of outdoor motor
- Inspect armaflex
- Inspect and test defrost controls
- Comp cap
- Comp amps
- LRA
- Inspect contactor
- Inspect start components
- Inspect thermostat wire
- Inspect surge protection
- Fan cap
- CFM amps
- Inspect compressor plug/terminal
- Inspect Schrader valve & caps
- Clean outdoor coil (cooling)
Indoor Section
- Inspect filter
- Inspect junction boxes
- Inspect indoor blower and motor for dirt buildup or restricted airflow
- Inspect bearings and lubricate (if needed)
- Inspect surge protection
- Test capacitor
- IDM amps
- Inspect indoor coil
- Inspect and clean condensate drain (cooling)
- Inspect condensate safety switch
- Inspect secondary drain system/pan
- Inspect duct seal at unit and secure panels
- Inspect attic insulation
- Inspect ductwork
- Inspect thermostat operation
- Tighten electrical connections
Gas Heat
- Inspect control board
- Clean flame sensor
- Inspect burner ignition
- Inspect door switch
- Inspect gas shut off and gas flex
- Inspect safety switch and heat exchanger
- Inspect main burners
- Inspect gas valve
- Inspect flue pipe
- Inspect inducer fan motor & pressure hose
- Gas pressure
Fill out the contact below to inquire about enrolling in our preventative maintenance plan!